What Is Included In a Plumbing Rough In Service?
A plumbing rough in service assumes a couple of things. On the one hand, it suggests that the drain and water supply pipes have been run through bored holes in the studs. It must also run through all the framing members. On the other hand, it suggests pipe constructions have been made.
At this phase of the plumbing rough in process, no faucets, sinks, toilets, or other fixtures have been put in place. If a concrete slab foundation will be constructed for the dwelling, the rough in plumbing will need to be done before pouring the concrete.
Plumbing Rough-In Process Steps
1. You Select, We Listen:
You choose where you want the plumbing fixtures—such as sinks, toilets, and bathtubs—installed. We want to understand your preferences before we get down to business.
2. Precise Planning
Our professional plumbers will mark the precise locations for each fixture so that the setup aligns with your stated preferences.
3. Drainage First
We start with the installation of water drain pipes to ensure a smooth flow and safeguard against debris interfering during the construction.
4. Water Supply Lines
After putting in the drain pipes, we run the water supply lines to each fixture. We use durable materials like PEX or copper pipes because of the longevity and efficiency they afford.
5. Pressure Test for Peace of Mind
Once everything is connected, our licensed plumbers perform an extensive pressure test to ensure proper function and no leaks. It’s part of our attention to detail and commitment to customer satisfaction.
6. Building Code Compliance
After a successful pressure test, a licensed inspector will check the rough in to verify it lines up with applicable local building codes and safety standards.
7. Ready for Final Install
Once we get the go-ahead, we proceed to the last phase—installing your fixtures and completing the job with precision.